Throttling device pressure method Throttling device pressure method, there are five kinds of orifice plate in terms of: angular contact pressure, flange pressure, span pressure, theoretical pressure and tube access pressure. As far as nozzles are concerned, only angled pressure and span pressure are used. Longlived 430 Stainless Steel Cut Wire Shot are all produced through German craftsmanship with bright, defect-free and pollution-free material. After strict processing like heat treating, wire drawing, electronic spiral cutting, passivation molding and other processes, our products are strictly in a accordance with German Spring Association standard VDFI8001, German industrial standards DIN8201 and American Aerospace Material Specification Standard. It is widely used for surface shot blasting, sand blasting and shot blasting of stainless steel parts, aluminum alloy die castings, and copper alloy parts. According to different composition, stainless steel is classfied several grades such as 304, 410, 430, 201 and 430 stainless steel Cut Wire Shot is the most popular abrasive of them as its excellent performance. The composition of 430 stainless steeel is: C≤0.12, Cr 16.00-18.00, Ni 0, Mn ≤1.25, P≤0.035, S≤0.030, Si≤0.75. So you can check if 430 Stainless Steel Shot could meet your requirement. Generally 430 stainless tseel cut wire shot could be classfied two kinds. One is as cut and the other is conditioned. Compared with as cut one, conditioned is without sharpe edges and corners and has near round shape. According to this, you can choose the more suitable one. 430 Stainless Steel Shot,Resistance Stainless Steel Shot,Sus430 Stainless Steel Cut Wire Shot,Ss430 Stainless Steel Cut Wire Shot Longlived Metal Products Co ., Ltd , https://www.longlivedmetalproducts.com
(l) The angle between the upper and lower pressure-retrieving holes and the front and rear end faces of the orifice plate (nozzle) are equal to half the diameter of the pressure-receiving hole, or equal to half the width of the pressure-gap annular gap. The penetrating point is exactly flush with the end face of the orifice plate, and the angled access pressure includes the ring chamber pressure and the separate drilling pressure.
(2) The distance between the center of the pressure on the upper and lower sides of the flange and the front and rear faces of the orifice plate is (25.4±0.8)mm.
(3) The distance between the center of the pressure taking hole on the upstream side and the front end face of the orifice (nozzle) is 1D, and the distance between the center of the pressure taking hole on the downstream side and the rear end face of the orifice (nozzle) is 1/2D.
(4) The distance between the center of the pressure taking hole on the upstream side of the theoretical pressure taking method and the front end face of the orifice plate is 1D ± 0.1D, and the spacing between the center line of the pressure taking hole on the downstream side and the rear end face of the orifice plate is β=d/D. Different sizes.
(5) Pipe connection pressure The center line of the pressure inlet hole on the upstream side is 2.5D from the front end face of the orifice plate, and the center line on the downstream side of the pressure extraction hole is 8D from the rear end face of the orifice plate.
Among the above five pressure-recovery methods, the most commonly used angle pressure method is flange pressure, followed by the flange pressure method. The main medium is the pressure difference between the gas liquid and the steam. For details, please refer to the throttle device design manual, or consult the relevant technical personnel of the company.