Chinese Car Brake Pads,Rear Axle Brake Pads For Volvo,Wva24012 Brake Pads For Rear Axle,Wva24011 Brake Pads DONGYING BORUI BRAKE SYSTEM CO.,LTD. , https://www.boruiauto.com
Tying a tire, leaking a tire, or puncturing a tire can cause the car to break down on the road. Many times you will find that when you don't need something, it will appear frequently in your field of vision, and when you desperately need it At the time, it could not find it.
When you tire on the road, when you tire, it is very difficult to go to the local air or tire repair. If you call for help, it will take time. If you happen to be on the highway, it will be even more troublesome. Or do it yourself, learn more about a skill, it is much faster than asking for help, and it is not difficult to change the spare tire.
First of all, you have to find a safe place. When the tires are flat, the car can still be opened. Therefore, you have to drive the car to the side of the road. It is best not to change it on the road. This will avoid which "big headed green" drove to pick you up to repair the car on the road. Then, make sure you can find the jack, the wrench to remove the tire nut, and the spare wheel. Collect these together and start changing the spare tire.
1. Park the parking brake and pull it tightly so that the car does not move back and forth.
2. Use a wrench to first loosen the nuts of the blow-by tire one by one, generally counter-clockwise to loosen the nuts. Just loose it and do not unscrew it.
3, Jack, first find the steel flank next to the leaky tire, do not top in the lower edge of the door, this fulcrum generally from the outer edge of about 10 cm, to determine the steel frame can be put below the jack.
4, raise the jack, pay attention to the rise, the jack should stand upright, do not tilt, or lower the body once again.
5. After the leaky tire is vacant, stop raising the jack and then use a wrench to unscrew the loosened nut one by one.
6. Hold the leaky tire with both hands and remove the tire with force. If you can't move it out, you can use your feet to jump over the outer edge of the tire and the entire wheel will loosen and then take it off.
7. Hold the spare tire on the wheel hub. When installing the wheel, note that the nut holes of the wheel must be aligned with the nut holes on the wheel. This requires a little time and patience.
8. Then tighten the tire nuts with your hands. Then tighten the nuts one by one with a tire wrench. Do not make any great effort. Just twist it in the end.
9, after all the nuts are screwed in the end, the progenitor slowly put down the jack, so that the spare tire powder.
10. Don't forget to tighten the nut again with a tire wrench. If your strength is not great, then use your strength to tighten it. If you are wide-open, it will be enough to use your 80% strength.